2.11 Re-Connecting Cables - Asus V-Series P5G31 Installation Manual

5. Connect the other end of the signal cable to the floppy disk drive connector
on the motherboard. See page 4-6 for the location of the floppy disk drive
connector.
6. Connect a 4-pin power cable from the power supply unit to the power connector
at the back of the floppy disk drive.

2.11 Re-connecting cables

You may have disconnected some cables when you were installing components.
You must re-connect these cables before you replace the chassis cover.
LED cables
Reset button
HDD LED
Power Switch
Power LED
System Panel Connector
Connect the reset button, power switch, power LED, and HDD LED cables to their
respective leads in the system panel connector on the motherboard.
ASUS V-Series P5G31
I
PLED PWRBTN
F_PANEL
+HD LED RESET
2-23