Troubleshooting; If You Have Any Of These Problems - Panasonic Panafax UF-744 User Manual

If You Have Any of These Problems

Mode
The display is blinking
During Installation
Document doesn't
feed/multiple feed
During Transmission
Document jam
Does not stamp
Stamp too light
Vertical lines on the
transmitted document
Transmission Copy Transmission Copy
Quality
Transmitted document
is blank
No recording paper
Recording paper jam
Recording paper
doesn't advance into
machine
D ring Reception During Reception
Recording paper
doesn't eject after
printing
Document auto
reduction doesn't work
Out of toner
Symptom
Battery is completely discharged. This may happen at first
installation. After setting the clock, the blinking will stop.
1. Check that your document is free of staples and paper
clips, and that it is not greasy or torn.
2. Check that your document is the right type to send through
a fax machine by consulting the list on "Documents You
Cannot Send". If your document has the characteristics
listed, make a photocopy of your document and send the
copy instead.
3. Check that the document is loaded properly.
4. Adjust the ADF Pressure.
The information code 031 will appear on the display if the
document becomes jammed.
1. Check if Stamp LED is lit.
2. Check Fax parameter No. 04 and No. 28 settings.
Replace stamp or refill ink.
Check own copy quality. If copy is OK, your machine has no
problem, report to the receiving party that they have a problem.
If copy is NG, clean the Document Scanning Area.
1. Make sure the document is set face down.
2. Check own copy quality. If copy is OK, your machine has no
problem, report to the receiving party that they have a
problem. If copy is NG, clean the Document Scanning Area.
The information code 010 will appear on the display if the paper
runs out.
The information code 001, 002 or 003 will appear on the display
if the paper gets jammed.
Make sure that there is paper in the Paper Cassette. Follow
the instructions for loading paper.
Check to see if the recording paper is jammed inside of the
machine.
Check Print Reduction settings.
The information code 041 will appear on the display if the Toner
Cartridge runs out of toner.

Troubleshooting

Action Page
24
39
40
139
8
136
42
35,36
142
137
137
18
135
18
135
60
16
131