Storing The Basic Settings And Adjustments - One Touch Operation; Using The Sleep Timer - JVC RX-888RBK Instructions Manual

Storing the Basic Settings and
Adjustments — One Touch Operation
JVC's One Touch Operation function is used to assign and store
different sound settings for each different playing source. By using
this function, you do not have to change the settings every time you
change the source. The stored settings for the newly selected source
are automatically recalled.
The following can be stored for each source:
• Volume level (see page 10)
• Loudness (see page 11)
• Input attenuator mode (see page 11)
• Subwoofer output level (see page 11)
• Balance (see page 12)
• Analog/digital input mode (see page 13)
• SEA modes (see page 22)
• DSP modes
– 3D-PHONIC mode settings (see page 26)
– DAP mode settings (see page 26)
– Surround mode settings (see page 27)
• DVD MULTI playback mode settings (see page 32)
On the front panel ONLY:
To store the sound settings
1. Press ONE TOUCH OPERATION.
The ONE TOUCH OPERATION lamp lights
up, then the previously memorized settings
are recalled.
2. Adjust the sound using the functions listed above.
The newly adjusted settings are memorized.
To recall the sound settings
With the ONE TOUCH OPERATION lamp lit, the settings for the
currently selected source are recalled when the source is selected.
To cancel the One Touch Operation function
Press ONE TOUCH OPERATION so that the lamp goes off.
(Even though the One Touch Operation function is canceled, the
recalled sound effects remain active.)
Notes:
• If the source is FM or AM (MW/LW), you can assign a different
setting for each band.
• The DSP modes and DVD MULTI playback mode cannot be used
at the same time.

Using the Sleep Timer

Using the Sleep Timer, you can fall asleep to music and know the
receiver will turn off by itself rather than play all night.
From the remote control ONLY:
Press SLEEP repeatedly.
The SLEEP indicator lights up on the display,
and the shut-off time changes as follows (in
minutes):
10
When the shut-off time comes
The receiver turns off automatically.
To check or change the time remaining until the shut-off time
Press SLEEP once.
The remaining time until the shut-off time appears in minutes.
• To change the shut-off time, press SLEEP repeatedly.
To cancel the Sleep Timer
Press SLEEP repeatedly until "SLEEP 00min." appears on the
display. (The SLEEP indicator goes off.)
• Turning off the power also cancels the Sleep Timer.
ONE TOUCH OPERATION
20 30 40 50 60
00 (Canceled)
SLEEP
70 80 90
16