Assigning Names To Preset Stations - JVC RX-730R Instructions Manual

Assigning Names to Preset Stations

TUNER MEMORY
TUNER MEMORY
Front panel
You can assign a name of up to five characters to each preset station (from preset channel number 1 to 20).
When a preset station is tuned in, its assigned name will appear on the display.
On the front panel only:
1. Tune in a preset station (preset channel number 1 to 20).
See page 21 for details.
2. Press MEMORY (next to the TUNER button).
The preset channel number starts flashing.
Note:
If you press Control % / fi while the preset channel
number is flashing, you can change the preset channel
number.
3. Press Control # # # # # (or @ @ @ @ @ ) until the first character
position starts flashing.
4. Press Control % % % % % / fi fi fi fi fi to select a character.
You can use characters listed below.
5. When a character you want appears, press
Control # # # # # (or @ @ @ @ @ ).
The next (or previous) character position starts
flashing.
6. Repeat steps 4 and 5 to enter up to five characters.
7. Press MEMORY (next to the TUNER button) again while the last selected character is flashing,
after you have assigned a name.
To erase the input characters
Insert blanks using the same procedure described above.
Available characters
Blank
A B
P Q R
5 6 7
CH–
100
CH–
100
CH–
100 1k
CH–
100
C D E F G H I
S T U V W X Y
8 9
See also
page 39.
MENU
VISUAL CONFIRMATION
1k 10k
VISUAL CONFIRMATION
1k 10k
VISUAL CONFIRMATION
10k
VISUAL CONFIRMATION
1k 10k
J K L M N O
Z 0 1 2 3 4
Page 22