JVC RX-7012VSL Instructions Manual page 40

To change the transmittable signals for
operating another manufacturer's DVD player
1. Press and hold AUDIO
2. Press DVD.
3. Enter manufacturer's code using buttons 1 – 9,
and 0.
See the list to the right to find the code.
4. Release AUDIO
After pressing DVD or DVD MULTI, you can perform the
following operations on a DVD player:
PLAY3:
Starts playing.
4:
Returns to the beginning of the current (or
previous) tracks.
¢:
Skips to the beginning of the next track.
STOP7: Stops playing.
PAUSE8:
Stops playing temporarily. To release it, press
PLAY3.
After pressing DVD or DVD
MULTI, these buttons can be used
for the DVD menu operations.
Note:
For detailed menu operations, refer to the
instructions supplied with the discs or the
DVD player.
Note:
Refer to the manual supplied with your DVD player.
5. Try to operate your DVD player by pressing one
of the above buttons.
• DO NOT forget to turn on the DVD player before pressing one
of the above buttons.
If there are more than one code listed for your brand of DVD
player, try each one until the correct one is entered.
37
.
.
– CENTER +
2
MENU
TEST – REAR • L +
4 5
ENTER
– REAR • R +
8
Manufacturer
JVC
DENON
PANASONIC
PHILIPS
PIONEER
RCA
SAMSUNG
SONY
TOSHIBA
YAMAHA
Manufacturers' codes are subject to change without
notice. If they are changed, this remote control cannot
operate the equipment.
3
6
9
Codes
00, 02
01
03
13
04, 05, 06
07
08
09
10
11, 12