JVC RX-7012VSL Instructions Manual page 38

To change the transmittable signals for
operating a CATV converter or DBS tuner
1. Press and hold CATV/DBS
2. Press CATV/DBS CONTROL.
3. Enter manufacturer's code using buttons 1 – 9,
and 0.
See the list to the right to find the code.
4. Release CATV/DBS
The following buttons can be used for operating the CATV
converter or DBS tuner:
CATV/DBS :
Turns on and off the CATV converter
or DBS tuner.
CH +/–:
Changes the channels.
1 – 10, 0, 100+ (+10): Selects the channels.
The 10 button will function as the
ENTER button if your equipment
requires pressing ENTER after
selecting a channel number.
Note:
Refer to the manual supplied with your CATV converter or DBS
tuner.
5. Try to operate your CATV converter or DBS
tuner by pressing CATV/DBS
When your CATV converter or DBS tuner turns on or off, you
have entered the correct code.
If there are more than one code listed for your brand of
CATV converter or DBS tuner , try each one until the correct
one is entered.
Note:
You cannot use both the CATV converter and DBS tuner at the same
time.
35
.
.
.
For CATV converter
Manufacturer
GENERAL INSTRUMENT 06, 07, 08, 09, 10,
HAMLIN/REGAL
JERROLD
OAK
PANASONIC
PIONEER
SCIENTIFIC ATLANTA
TOCOM
ZENITH
Manufacturers' codes are subject to change without
notice. If they are changed, this remote control cannot
operate the equipment.
For DBS tuner
Manufacturer
JVC 56, 57, 67
AMSTRAD 43, 44, 45, 46, 47, 48, 49
BLAUPUNKT 30
ECHOSTAR 50, 51, 67
GOLDSTAR 31
GRUNDIG 32, 33
HIRSHMANN 48, 52, 53, 54, 55
INSTRUMENT 68
ITT/NOKIA 34
KATHREIN 52, 58, 59, 60, 61, 62, 63
NEC 35, 36
ORBITECH 48
PHILIPS 37, 38
RCA 65
SAMSUNG 39, 40
SCHWAIGER 61, 64
SIEMENS 41, 42
SONY 66
TECHNISAT 48
Manufacturers' codes are subject to change without
notice. If they are changed, this remote control cannot
operate the equipment.
Codes
11, 12, 13, 14, 29
01, 02, 03, 04, 05
06, 07, 08, 09, 10,
11, 12, 13, 14
15, 16, 17
18, 19, 20
21, 22
23, 24, 25
26
27, 28
Codes