Lubrication; Transmission; Engine Oil Change - Craftsman 917.204130 Operator's Manual

12/I211/52 1/365 25h 50h 100h 200h 300h
Engine Oil Change
NOTE: Change the engine oil when the engine is warm. Refer
to the engine owner's manual for the correct replacement oil
and filter change recommendations.
1, Park on a level surface, Apply parking brake,
2, Clean the dirt and debris from the area around the oil fill
cap,
3, Remove the cap/dipstick,
4, Locate the drain hose at the left rear of the engine near
the bypass linkage,
12/12 Every year
1/52 Every Week
1/365 Every day
Lubricate with
grease gun
Filter change
Oil change
Level check
General
5,
Remove the ignition key to prevent unintentional movements
during lubrication,
6,
When lubricating with an oil can, it must be filled with engine
oil, 7,
8,
When lubricating with grease, unless otherwise stated, use a
high grade molybdenum disulphide grease,
For daily use, the machine should be lubricated twice weekly, 9,
Wipe away excess grease after lubrication, 10,
It is important to avoid getting lubricant on the belts or the
drive surfaces on the belt pulleys, Should this happen, attempt
to clean them with spirits, If the belt continues to slip after
cleaning, it must be replaced, Gasoline or other petroleum
products must not be used to clean belts,
IMPORTANT INFORMATION Use minimal lubrication
and remove excess lubricant so that is does not come into
contact with belts or belt pulley drive surfaces.
--/
f
Place an adequately sized container under the end of the
drain hose and remove the oil drain plug,
Allow the oil to fully drain from the engine,
Replace the drain hose plug and tighten securely,
Fill the engine with new oil to the bottom of the fill tube
threads, Check the level with the dipstick,
Replace the oil fill cap securely when the oil level is FULL,
Refer to the Service Journal for oil checking and changing
intervals and change recommendations,
_ WARNING! The engine drain plug is located close to
the muffler. To prevent burns, the engine should be shut off
and allowed to cool slightly so the engine is still warm but
the surrounding surfaces and oil are not.
Transmission
The transmission is maintenance free with no need for level
checks or oil changes, If a leak occurs, replace the unit or
contact a Craftsman Service Center or authorized service
workshop,