Attachment Of The Cp-Xy15Hc1 Horizontal Flying Cradle; Attachment Of The Cp-Xy15Ab1 Variable Angle Bracket - Pioneer XY-152 User Manual

Xy series 15 inch two way loudspeaker

Hide thumbs Also See for XY-152:

Table of Contents

Attachment of the CP-XY15HC1 Horizontal Flying Cradle

Engb

Using the supplied M10 socket head bolts, align the mounting holes in the end

mounts of the yoke with the mounting points on the top and the bottom of the

enclosure. Ensure that both the flat and locking washers are used — the flat washer

should be in contact with the cradle. Tighten the bolts to ensure a solid fit. Once the

desired angle of the loudspeaker is set, tighten the levers on the cradle to lock the

position in place. The points on the top of the flying cradle can be used for perma-

nent installations or to secure a hook clamp.

Ensure that an M10 eyebolt is secured to the rear point on the XY-152 enclosure to

use as a secondary safety feature.

Using the supplied M10 hex head bolts, align the mounting holes in the flying

bracket with the mounting points on the top or the bottom of the enclosure. Ensure

that both the flat and locking washers are used — the flat washer should be in

contact with the cradle. Tighten the bolts to ensure a solid fit. Finally, attach a hook-

clamp to the mounting point.

The flying bracket works on the centre of gravity of the XY-152. Moving the pickup

point to the rear of the enclosure will add down-tilt, and moving to the front of the

enclosure will apply up-tilt. For larger down-tilt angles, position the pivot on the last

hole and use the point on the rear or underside as a pull-back.

Ensure that an M10 eyebolt is secured to the top point on the XY-152 enclosure to use

as a secondary safety feature.

Table of Contents