Start-Up/Shutdown; Switch Between Function Modes - Navig8r NAVSPORT1080 User Manual

START-UP/SHUTDOWN

1. START-UP: Press and hold the power button until the welcome screen is displayed.
Note: The remote control cannot turn on the camera. You must use the power button on the camera
2. SHUTDOWN: Press and hold the power button until the Goodbye screen is displayed.
Note 1: The camera will automatically shut down after 5 minutes of inactive use to conserve power.
Note 2: If there is not enough power the low power battery icon will flash. When power has been exhausted
the camera will shutdown.
Note 3: The camera can also be turned off with the remote control.

SWITCH BETWEEN FUNCTION MODES

Tap the icon at the top left of screen to change between modes. A different icon will appear each time.
Video mode: Record video
(To start recording press the shutter button or tap centre screen)
Car Mode: Record Video
(To start recording press the shutter button or tap centre screen)
NOTE 1: THE SCREEN AUTOMATICALLY FLIPS UP-SIDE-DOWN TO
FACILITATE CORRECT IN-CAR MOUNTING. THIS CAN NOT BE CHANGED.
Note 2: This mode cycle-records video in 3 minute blocks. A minimum SD card space of
500MB if required for this feature to operate correctly, otherwise an error message will
be displayed. Remember to press STOP or turn the unit off in case of an accident to
preserve recorded files.
Picture mode: Digital Still Camera operation
(To take a single picture, press the shutter button or tap centre screen)
9