Function Select Mode; Setup Operation - Kenwood TH-D72A Instruction Manual
144/440 mhz fm dual bander; 144/430 mhz fm dual bander
Hide thumbs
Also See for TH-D72A:
- Instruction manual (156 pages) ,
- Service manual (97 pages) ,
- Manual (3 pages)
Table of Contents
Advertisement
SETuP OPERATION
Function Select mode
Press [F] to enter Function Select mode. In this mode you can scroll F–0 through
F–# by pressing
. After accessing the desired function, press [ OK],
[
]/[ ]
then press
to select the desired parameter.
[
]/[ ]
Pressing [F], [0] ~ [9] or [ ], [#] is a much simpler method. For example,
pressing [F], [8] switches the Tone function ON or OFF. (Refer to the keypad
explanations on pages 10 ~ 11.)
Note: You can verify the battery capacity while in Function Select mode.
Full
Medium
Low
Very Low (recharge)
menu mode
Press [MENU] to enter Menu mode. In this mode you can access the desired
and [ OK] or entering digits directly from the
menu item by pressing
[
]/[ ]
keypad (0 ~9, A, B, C, D, E ( ),and F (#) only). For further information, refer to
"MENU MODE" {page 23}.
22
Advertisement
Table of Contents
