Kenwood TH-D72A Instruction Manual page 21

[LIST] (5)
Press [LIST] to display the Station list <APRS>.
Press [F], [LIST] to display the DX Cluster list <APRS>.
[BCON] (6)
Press [BCON] to enter the Beacon Transmit mode (TX Beacon method is
Manual) or turn the Beacon function ON or OFF (TX Beacon method is other
then Manual) <APRS>.
Press [F], [BCON] to enter the Quick Beacon mode <APRS>.
[REV] (7)
Press [REV] to turn the Reverse function ON or OFF.
Press [REV] (1s) to turn the Automatic Simplex Checker ON.
Press [F], [REV] to enter the Vice Alert function setup mode <APRS>.
[TONE] (8)
Press [TONE] to turn the Tone function ON.
• Each time you press [TONE], the function cycles through the following: Tone ON
>> CTCSS ON >> DCS ON >> Cross Tone ON >> OFF.
Press [F], [TONE] to enter the Tone frequency, CTCSS frequency, DCS code,
or Cross Tone setup mode.
Press [F], [TONE] (1s) to start the Tone frequency ID, CTCSS frequency ID,
or DCS code ID scan.
[PF] (9)
Press [PF] to activate its programmable function. The default function is
"Weather Channel" (TH-D72A)/ "Memory Name <-> Frequency" (TH-D72E).
[MHz] ( )
Press [MHz] to enter the Offset Direction selection mode.
• Each time you press [MHz], the offset direction cycles through the following: plus
(+) direction –> minus (–) direction –> –7.6 MHz (TH-D72E only) –> OFF.
Press [MHz] (1s) to start the MHz scan.
Press [F], [MHz] to enter Offset Direction setup mode.
[DUAL] (0)
Press [DUAL] to switch the Single band mode and Dual band mode.
Press [F], [DUAL] to turn the Full duplex function ON or OFF.
[ENT] (#)
Press [ENT] to enter Frequency or Channel number entry mode.
Press [F], [ENT] to enter Frequency step setup mode.
11