Goodman GME95 Technical Manual page 10

PRODUCT DESIGN
Thermostats:
NOTE: Complete lineup of thermostats can be found in the Thermostat Specification Sheets.
Filters:
Filters are required with this furnace and must be provided by the installer. The filters used must comply with UL900 or
CAN/ULCS111 standards. Installing this furnace without filters will void the unit warranty.
This furnace has provisions for the installation of return air filters at the side and/or bottom return. The furnace will
accommodate the following filter sizes depending on cabinet size:
Cabinet
Width
(in.)
All
Refer to Minimum Filter Area tables to determine filter area requirement. NOTE: Filters can also be installed elsewhere in
the duct system such as a central return.
10
Upflow Filters
SIDE RETURN
Approx.
Nominal
Flow Area
Filter Size
2
(in.)
(in )
16 x 25 x 1 400
COOLING AIRFLOW REQUIREMENT (CFM)
600 800
0403BXA* 388* 388*
0603BXA* --- 647*
0805CXA* --- ---
1005DXA* --- ---
*Minimum filter area dictated by heating airflow requirement.
Disposable Minimum Filter Area (in
[Based on a 300 ft/min filter face velocity]
COOLING AIRFLOW REQUIREMENT (CFM)
600 800
0403BXA* 194* 194*
0603BXA* --- 324*
0805CXA* --- ---
1005DXA* --- ---
*Minimum filter area dictated by heating airflow requirement.
Permanent Minimum Filter Area (in
[Based on 600 ft/min filter face velocity]
BOTTOM RETURN
Cabinet Nominal
Width Filter Size
(in.) (in.)
17-1/2 14 x 25 x 1
21 16 x 25 x 1
24-1/2 20 x 25 x 1
(1) Flanges on bottom return must be unfolded
1000 1200 1400
480 576 ---
647* 647* 672
--- 777* 777*
--- 971* 971*
2
)
1000 1200 1400
240 288 ---
324* 324* 336
--- 388* 388*
--- 486* 486*
2
)
(1)
Approx.
Flow Area
2
(in )
350
400
500
1600 1800 2000
--- --- ---
--- --- ---
777* 960* 960*
971* 971* 971*
1600 1800 2000
--- --- ---
--- --- ---
388* 480* 480*
486* 486* 486*