•
Take the side blocks off by removing screws.
•
Examine the sides of the mixing chamber for scratch-
es and/or material build-up. Carefully, without
scratching the seal surfaces (sides), remove any
accumulated material. Solvent can be used to wash
accumulated material off of chamber, side blocks, etc.
Keep the gun chamber tilted toward the ground so
that solvent does not run back into gun. Certain
solvents will attack o-rings on chamber shaft causing
swelling and deterioration of o-rings.
•
Place generous amounts of high quality, white lithium
grease (Part No. 117773) in each side of the gun
front housing and on the side block seals.
Section 3 - General Information: Maintenance
ti21611a
•
Use correct size drill bit to clean out the mixing
chamber exit passage. Use correct size drill bit to
clean the inlet side holes of the mixing chamber tak-
ing care not to scratch the mixing chamber's polished
surfaces (refer to the drill chart).
•
Re-assemble the side blocks and tighten the screws.
Grease should appear at the tip of the mixing cham-
ber.
DO NOT open the air switch on the gun because this
will purge grease from the gun. The grease should
be allowed to remain in the gun overnight.
16
ti21611a