Advertisement
Expansion Unit Interface
This interface is used to connect an expansion unit that can transmit data over
a Fieldbus or similar type of network.
Tool Connector
Connects a Data Transfer Cable or bar code reader.
Connect the GLC to a serial printer via the Data Transfer Cable and
a User-created conversion cable.
GLC2300 Series User Manual
Ethernet Interface
This interface complies with the IEEE802.3 standard for Ethernet (10BASE-T)
connections. This interface uses an RJ-45 type modular jack (8 points).
CF Card Interface
This slot accepts a CF Card.
5
Installation
Confirm the Installation Gasket's Positioning
It is strongly recommended that you use the gasket. It absorbs vibration in
addition to repelling moisture.
Place the GLC on a level surface with the display panel facing downward.
Check that the GLC's installation gasket is seated securely into the gasket's
groove, which runs around the perimeter of the panel's frame.
• Before installing the GLC into a cabinet or panel, check that
the installation gasket is securely attached to the unit.
• A gasket which has been used for a long period of time may
have scratches or dirt on it, and could have lost much of its
dust and drip resistance. Be sure to change the gasket peri-
odically (or when scratches or dirt become visible).
Rear face
Create a Panel Cut and insert the GLC into the panel from the front
Unit: mm [in]
Panel
156.0
+1
[6.14
+0.04
]
0
0
-25-
Gasket
under 4-R3
Panel
Panel thickness:
1.6mm[0.06in] to
5.0mm[0.20in]
GLC
Advertisement
