H.264 4-CH User Manual page 42

6 Network access settings and cloud technology introduction
6.1LAN access settings
1. Network connection
1. Before the WEB operation, need to connect this device with the network.
2. Enter DVR "main menu" "network" to set correct IP address, subnet mask ,DNS and gateway port,default is ok
(the IP segment of the device should be the same with that on PC computer, if disconnected, please check
device IP was successfully connected .)
2. Login
Step 1: after connecting successfully, you can login to view.
Open a web browser; input the IP address of the login device in the address bar. For example the device w
IP address 192.168.1.10, HTTP port 80, then input http://192.168.1.10 in the address bar and connect. If
HTTP port is not 80, such as 81, then need to add port when viewing, as:
Note: If the PC connects the device at first time, when open system, the security warning will pop up whether to accept
the WEB control web. cab, please choose to accept the user, the system will automatically identify the installation. (If
the system is prohibited to download, please confirm whether you have other prohibited controls to download plug-ins,
and reduce the IE security level, permit unsigned plug-in to operate. The following interface will pop up after
successfully connected.
Step 2: Login. Enter the user name and password, the administrator user name of factory default is admin,
password is blank. After login, please promptly modify the administrator password.
Login is successful, display the interface as shown below.
Picture 6.1 WEB Login interface
42
USER MANUAL
http://192.168.1.10:81