Programing Conveyor Speed; Programing Values For Menu Items - Holman QCS2 Series Installation And Operation Instructions Manual

PROGRAMING
A. CONVEYOR SPEED (temporary setting)
The conveyor speed is programmable with a range from 0 to 99 with 0 being the slowest and 99
being the fastest. Each menu item can have independent conveyor speed settings.
The LIGHT and DARK buttons can be used to temporarily change the conveyor speed.
Pressing the LIGHT button once will increase the conveyor speed by 15%. The word
LIGHT will be displayed. Pressing twice will increase the conveyor speed by 30% and
XLIGHT will now be displayed.
Pressing the DARK button once will decrease the conveyor speed by 15%. The word
DARK will be displayed. Pressing twice will decrease the conveyor speed by 30% and
XDARK will now be displayed.
NOTE: After 60 seconds, the conveyor speed will return to the pre-programmed setting.
WHEN USING THE LIGHT AND DARK BUTTONS TO ADJUST THE CONVEYOR
SPEED FOR A SINGLE ORDER OF PRODUCT, IT IS IMPORTANT TO REMEMBER
TO ALLOW THE PRODUCT ALREADY IN THE TOASTER TO EXIT BEFORE
CHANGING THE SPEED SETTING.
B. PROGRAMING VALUES FOR MENU ITEMS
To make a program change to the top heat, bottom heat, or conveyor speed, you must first be in the
menu item you want changed. Example: to change the programmed conveyor speed for bagels, the
display must read BAGEL. To change the programmed conveyor speed for TOAST, the display must
read TOAST and so on for each menu item.
1) Select the menu item you want to change i.e. TOAST, MUFFIN, BAGEL or OTHER.
2) Press and hold both ( + ) AND ( - ) buttons for 3 seconds until the display goes
blank, release the buttons and the display will show three characters for the menu
item elected and the last two characters for the current value setting, i.e. TST, MUF,
BGL and OTH. The red L.E.D. light for top heat at the bottom of the label will flash.
3) Press the ( + ) or ( - ) buttons to increase or decrease the setting for the top heat.
4) Press the button for the menu button again and the red L.E.D. for the bottom heat
will flash.
5) Press the ( + ) or ( - ) buttons to increase or decrease the setting for the bottom heat.
6) Press the button for the menu button again and the red L.E.D. for the conveyor
speed will flash.
7) Press the ( + ) or ( - ) buttons to increase or decrease the setting for the conveyor
speed.
8) To skip one feature setting with out making any changes, press the menu item button
one time and the red L.E.D. light for the next item will now flash.
9) To change the POWER SAVER values press the SAVER button or to save your new
setting(s), and exit the program mode press the menu button.
10) The last two characters in the display will show MN for minutes.
11) The first three characters will be numerical to represent the time setting.
12) Press the ( + ) or ( - ) buttons to increase or decrease the setting for the savor mode
time. The minimum value is 15 minutes to maximum value of 480 minutes.
13) Press the SAVER button to change the power reduction using the ( + ) or ( - ) buttons
to increase or decrease the setting.
14) Press the POWER SAVER button to save changes and to exit.
9
QCS
e
®