Cleaning And Maintenance - Kenwood SC7000 Instruction Manual

Floor sweeper/steam mop
Table of Contents

Advertisement

E N
3) Alternate use
(Suction - Steam)
IMPORTANT: The two functions are always used alternately, but at the same time.
With the appliance plugged into the mains power and sufficient water in the tank (M), it is
possible to use the appliance, alternating the two functions (follow the instructions above);
suction or steam can be enabled simply by tilting the handle (I) and it is possible to pass
from one function to another by tilting the handle (I) back in the other direction, inverting the
direction of use (Fig. 3) and as a result, rotating the handgrip (H) by 180° .
When the handle (I) is perfectly upright, the appliance is switched off.
IMPORTANT: When the appliance is plugged into the power mains, take care to avoid switching it
on accidentally by knocking against the handle (I).
After use, unplug the appliance from the power mains and before putting it away, wind the power
cord around the special hooks (E).

CLEANING AND MAINTENANCE

IMPORTANT: NEVER PLACE THE APPLIANCE BODY, PLUG OR POWER CORD IN WATER OR
OTHER LIQUIDS; WIPE THEM CLEAN WITH A DAMP CLOTH.
IMPORTANT: ALWAYS UNPLUG THE APPLIANCE WHEN NOT IN USE AND BEFORE INSERTING
OR REMOVING SINGLE PARTS OR CLEANING IT.
IMPORTANT: Never use aggressive cleaning substances (stain removers, solvents) that could cor-
rode the plastic.
Emptying the container (N) and cleaning the filter (O)
IMPORTANT: EMPTY THE DUST CONTAINER (N) AFTER EVERY USE. THE FILTER (P)
SHOULD BE CLEANED REGULARLY TO MAINTAIN MAXIMUM SUCTION EFFICIENCY.
- Remove the dust container (N) complete with filter (O) from the cleaner pad and then remove the
filter (O) (Fig. 9).
- Empty the container (N) into a bag and shake the filter (O) to remove any debris.
After a great deal of use, it is possible to wash the filter gently, by hand, using lukewarm water and
a mild detergent. Rinse thoroughly and make sure that the filter is completely dry before refitting it.
- Refit the filter (O) into the container (N) and then refit the container into its seat on the cleaner
pad.
IMPORTANT: NEVER USE THE CLEANER WITHOUT ITS FILTER. THIS CAN CAUSE DAMAGE
TO THE MOTOR AS WELL AS RENDERING THE GUARANTEE NULL AND VOID.
- 6 -

Advertisement

Table of Contents
loading

Table of Contents