JVC 0303NHMMDWJEIN Instructions Manual page 15

Video component connections
Use the cables with RCA pin plugs (not supplied).
Connect the white plug to the audio left jack, the red plug to the
audio right jack, and the yellow plug to the video jack.
• If your video components have S-video (Y/C-separation) and/or
component video (Y, P , P ) terminals, connect them using an S-
B R
video cable (not supplied) and/or component video cable (not
supplied). By using these jacks, you can get better picture quality
in the order—Component video > S-video > Composite video.
If your video components have an AV COMPULINK jack
See also page 40 for detailed information about the connection
and the AV COMPU LINK remote control system.
IMPORTANT:
This receiver is equipped with the following video jacks—composite
video, S-video and component video jacks. You can use any of the
three to connect a video component.
However, the video signals from one type of these input jacks are
transmitted only through the video output jacks of the same
type.
Therefore, if a recording video component and a playing video
component are connected to the receiver through the video jacks of
different type, you cannot record the picture. In addition, if the TV and
a playing video component are connected to the receiver through the
video jacks of different type, you cannot view the playback picture on
the TV.
VCR
To listen to the sound after connection, press VCR.
A B
VCR
R
L
VCR
R
L
Å To audio input
ı To audio output
Ç To S-video output
Î To composite video output
‰ To S-video input
Ï To composite video input
C D E
OUT
(REC)
IN
(PLAY)
TV and/or DBS tuner
To listen to the sound after connection, press TV SOUND/DBS (or
TV/DBS on the remote control).
R
A
L
TV
When "TV" has
been assingned as
the source name
(see page 19), no
signal comes out of
these terminals.
B
C
D
Connect the TV to appropriate MONITOR OUT jacks to view
the playback picture from any other connected video
components.
Å To audio output
ı To component video input
Ç To S-video input
Î To composite video input
F
R
A
L
DBS
D
B
C
Å To audio output
ı To component video output
Ç To S-video output
Î To composite video output
Notes:
• When connecting a DBS tuner to the TV SOUND/DBS IN jacks,
change the source name to "DBS," which will be shown on the
display when selected as the source. Otherwise you cannot view
any picture from DBS tuner. See page 19 for details.
• When connecting a DBS tuner to the component input jacks (DBS
IN), make the component video input setting correctly for AV
COMPU LINK. See page 28 for details.
MONITOR
OUT
P P
Y
B R
TV SOUND
DBS
IN
MONITOR
OUT
DBS
IN
TV SOUND
DBS
IN
DBS tuner
12