Panasonic PV-GS19P Service Manual page 50

8.3.3. PREPARATION
1. Insert a flat headed (-) screwdriver or similar object, remove
the EVR Cover.
2. Connect the Connection Adaptor and the 2 EVR Connector
Boards. Then, connect the 30 pin Flat Cables to P101 and
P102 on the Interface Board.
Fig. E1-1
PV-GS19P / PV-GS31P / PV-GS32P / PV-GS35P / PV-GS19PC / PV-GS31PC / PV-GS34PC / PV-GS35PC
Note:
When connecting them, pay attention to the direction of
them.
3. Connect them to the Connector B2 on the Main C.B.A.
4. Connect the AC Adaptor to the camcorder.
5. Connect the P106 on the Interface Board to RS232C of the
PC with Inter Link Cable.
6. Set the SW115 (M103 EXMOD1) on the Interface Board to
"GND."
7. Set the SW110 (RS232C SEL) on the Interface Board to
"M3."
8. Set the SW114 (M103 VPP) on the Interface Board to "3V."
9. Set the SW103 (RECI) on the Interface Board to "OFF."
10. Set the SW108 (BST TEST) on the Interface Board to
"OFF."
11. Set the SW109 (IRIS) on the Interface Board to center.
12. Set the SW111 (5V SEL) on the Interface Board to "CAM
5V."
13. Set the SW113 (POWER ON) on the Interface Board to
"NORM."
14. Power on the unit.
53
Fig. E1-2