Deck Leveling Adjustment - Ferris CCW36 Series Operator's Manual

Deck Leveling Adjustment

To Level the Mower Deck:
1. Park the machine on a flat, level surface. Disengage
the PTO, stop the engine and engage the parking brake.
Check the tires for proper levels of inflation.
2. Pull the cutting height adjustment handle (A, Figure 28)
up and out of the handle lock position (B) and crank the
handle clockwise and adjust the deck to the 3" (7,6 cm)
position.
3. Repeat process for other side of machine. Both sides of
the mower deck must be adjusted to the same height.
4. Place 2 x 4 blocks under the rear of the mower deck
with the 3-1/2" sides being vertical. See Figure 29.
5. Loosen the deck leveling hardware (B, Figure 29) on
both sides of the machine.
6. Make sure that the rear of the deck is resting on the 2 x
4's. Tighten the deck leveling hardware on both sides of
the machine.
7. Remove all 2 x 4 blocks from under the mower deck.
Rear & Side
Discharge Decks
B
Figure 29. 2 x 4 Locations
A. 2 x 4 Blocks
B. Arrow Indicating the Front of the Machine
B
Figure 28. Remove the Cutter Deck Guard
A. Cutter Height Adjustment Handle
B. Handle Lock Position
C. Cutting Height Indicator
D. Deck Leveling Hardware
Side Discharge
A
Timed Decks
Regular Maintenance
A
C
A
B
D
33