Checking Tire Pressures; Pushing The Unit By Hand - Ferris CCW36 Series Operator's Manual

Check Tire Pressures
Tire pressure should be checked periodically, and
maintained at the levels shown in the chart. Note that these
pressures may differ slightly from the "Max Inflation"
stamped on the side-wall of the tires. The pressures shown
in Specifications provide proper traction, improve cut
quality, and extend tire life.
Pushing the Mower By Hand
NOTICE
Towing the units will cause hydraulic pump and wheel
motor damage. Do NOT use another vehicle to push or
pull this unit.
1. Disengage the PTO, engage the parking brake, turn the
ignition OFF, and remove the key.
2. Locate the transmission release levers (A, Figure 3) by
the rear wheels of the unit.
3. To disengage the pumps (free-wheel position), pull both
transmission release levers back and out so they lock in
the disengaged (free-wheel) position.
4. Disengage the parking brake.
The unit can now be pushed by hand.
5. After moving the unit, re-engage the pumps (drive
position) by pulling the transmission release levers
rearward and inward to release them from the
disengaged position and then allow them to move to the
engaged (drive) position.
Figure 2. Checking Tire Pressure
B
C
Figure 3. Transmission Release Levers (LH Shown)
A. Transmission Release Levers
B. Engaged Position (Drive Position)
C. Disengaged Position (Free-Wheel Position)
Operation
A
17