Sanyo MDF-192 Instruction Manual page 12

FREEZER COMPONENTS
1. Lock
2. Door: Hinged type. The door can be opened in any angle on the way to full open.
3. Magnetic door gasket: Seals the door and prevents leakage of cold air.
4. Inner lid: Serves as a means of reducing cold air leakage when the door is open. Remove the frost
before it is accumulated too much.
5. Access port: Serves a means of leading the measuring cable from the freezing room to the outside.
6. Caster: 4 casters are provided. They make the moving of the unit easier.
7. Leveling foot: Serves to adjust the height and to settle the frame.
8. Temperature display area: The digital temperature indicator, alarm lamp, and filter check lamp are
installed.
9. Exhaust air vent: Be careful not to block this.
10. Control panel cover
11. Control panel cover lock: To lock the control panel cover to avoid the setting by accidental
contact.
12. Control panel: Temperature set key, power switch and so on are installed. MDF-192AT has a
temperature recorder and switches of back-up system. Refer to page 12 for details.
13. Back-up system joint (MDF-192AT only): It is positioned at rear of the unit. Serves to connect
with the pipelines from the liquid CO cylinder.
2
14. Side panel: For cleaning the condenser filter and condenser. The remote alarm terminal is located
inside the panel.
11