Gearboxes And Axles; Rear Axle Transfer Gearbox - Gehl 418T Wheel Operator's Manual

Maintenance
Maintenance
5.8

Gearboxes and axles

5.8.1

Rear axle transfer gearbox

Checking the oil level
B
C
Fig. 156: Rear axle transfer gearbox
Top up the oil level
5–22
5
Maintenance of these components is limited to checking the oil levels and to changing the
oil at prescribed intervals – see maintenance plans in the Annex.
☞
Proceed as follows:
• Park the machine on level ground when the gearbox is at operating temperature
• Clean and unscrew plug A on transfer gearbox B
If the oil level is below the opening or if the oil level cannot be seen at all:
• Top up with oil – see section 5.15 Engine fluids and lubricants on page 5-39
If the oil level is correct:
• Tighten plug A with a new sealing ring to ensure an oil-tight seal
A
☞
Proceed as follows:
• Park the machine on level ground when the gearbox is at operating temperature
• Clean and unscrew plug 156/A on transfer gearbox 156/B
• Fill with oil until it runs out of the filler opening – see section 5.15 Engine fluids and
lubricants on page 5-39
If the gearbox oil level remains constant:
• Tighten plug 156/A with a new sealing ring to ensure an oil-tight seal
NOTE:
Only use new sealing rings for oil filler and drain plugs. Drain oil only after running
the machine for a long period of time!
AP0902