Strong SM-RAZOR-F-M Instruction Manual page 5

A. Pre-drill holes into concrete using 5/16" drill bits to a depth of 2 1/2". Insert
concrete Wall Anchors (B) and tap in-with hammer, if necessary (Figures 2 & 3).
B. Insert the four Lag Screws (A) into the Wall Anchors through the Wall Plate and tighten
all bolts.
WARNING: Tighten bolts so that wall plate is firmly attached, but do not over tighten.
Over tightening can damage the bolts, greatly reducing their holding strength.
Figure 2
Correct
plas ter/
drywall
concrete
Figure 2
© 2012 STRONG
Figure 3
Incorrect
Drill holes and
plaster/
insert anchors.
drywall
Place wall arm
assembly plate
concrete
over anchor and
SM-RAZOR-F Installation and Users Manual
secure with
Flange Bolt
lag screw.
Tighten all
lag screws.
Concrete
Wall
Wall Arm
Figure 4
pg.5