WARNINGS: • Installation of this product should be done by a qualified professional. • Do not begin installation before reviewing and understanding these instructions. • Ensure the mounting wall used can safely support 4 times the combined weight of the mount and chosen display. • Under no circumstances should this product be mounted to metal studs. • The manufacturer does not accept responsibility for incorrect installation. CAUTION: This wall mount is intended for use only with the maximum weight of 100 lbs for models SM-RAZOR-F-M & SM-RAZOR-F-L; 150 lbs for model SM- RAZOR-F-XL. Use with heavier than the maximum weight indicated may result in instability causing possible injury. SPECIFICATIONS TOOLS REQUIRED Maximum Load: • Power Drill SM-RAZOR-F-M 100 lbs. • 5/6” and 3/16” Drill Bit SM-RAZOR-F-L 100 lbs.
SM-RAZOR-F Installation and Users Manual INSTALLATION Step 1: Mounting the Wall Bracket Assembly Figure 1 For Mounting on a Stud Wall A. Pre-drill holes into two wood studs using a 3/16” drill bit. Be sure to drill into the center of the studs at least 2-1/2” deep. The use of a stud finder is highly recommended. B. Insert the Lag screws (A) into holes through the Wall Plate and tighten. (Figure 1). WARNING: Tighten bolts so that wall plate is firmly attached, but do not over tighten. Over tightening can damage the bolts, greatly reducing their holding strength. For Mounting on a Concrete Wall WARNING: When installing wall bracket on cinder block: • Verify first that you have a minimum of 1-3/8” of concrete thickness to be used for the concrete anchors.
Page 6
SM-RAZOR-F Installation and Users Manual Step 2: Mount Arms to television A. Determine the diameter of the screw Figure 4 (parts C through P & U) your TV requires by carefully trying to hand-thread one into the threaded insert on the rear of the TV. If there is any resistance, stop immediately. B. Spacers are commonly needed on televisions with curved backs or recessed screw inserts. The screw will thread through the appropriate washer (Q or R), any spacer needed (S or T) and the arms into the TV. C. Ensure the arms are installed flat side to television and are square to each other after all screws have been installed (Figure 4). D. Slide the clip up to lengthen and down to shorten the release string. Adjust the height of the Arm release to be above the bottom of the TV. (Figure 5). Figure 5 Lengthen Shorten Top of Arm pg.6...