Connecting The Tv - Sony Bravia KDL-32L504 Operating Instructions Manual

Connecting the TV
Cable System or VHF/UHF Antenna System
You can enjoy high-definition and standard-definition digital programming (if available in your
area) along with standard-definition analog programming.
This TV is capable of receiving unscrambled digital programming for both cable (QAM and
8VSB) and external VHFIUHF antenna (ATSC).
Cable or VHF/UHF (or VHF only)
75-ohm coaxial cable
--IIII(W1:]I
--eSI
Rear of
TV
CABLE/ANTENNA
~
..
• It is strongly recommended that you connect the CABLE/ANTENNA input using a 75-ohm
coaxial cable to receive optimum picture quality. A 300-ohm twin lead cable can easily be affected
by radio frequency interference, resulting in signal degradation.
Cable System and VHF/UHF Antenna System
Use an optional A-B RF switch (not supplied) to switch between the cable and over-the-air antenna
programming, as indicated below.
AlB RF Switch
cable~·I.I
.~.::EI) Rear of
TV
Antenna~.
m
CABLE/ANTENNA
• Be sure to set the Signal Type setting to Cable
or
Antenna found under the Channel settings
for your input signal (see page 30).
(Continued)
9