Connecting The Tv; Cable System Or Vhf/Uhf Antenna; System; Cable System And Vhf/Uhf Antenna - Sony BRAVIA KDL-40R350D Operating Instructions Manual

Connecting the TV

Cable System or VHF/UHF Antenna System
You can enjoy high-definition and standard-
definition digital programming (if available in your
area) along with standard-definition analog
programming.
This TV is capable of receiving unscrambled digital
programming for both cable (QAM and 8VSB) and
external VHF/UHF antenna (ATSC).
Cable or VHF/UHF (or VHF only)
75-ohm
coaxial cable
Note
• It is strongly recommended that you connect the CABLE/
ANTENNA input using a 75-ohm coaxial cable to receive
optimum picture quality. A 300-ohm twin lead cable can
easily be affected by radio frequency interference,
resulting in signal degradation.

Cable System and VHF/UHF Antenna

System

Use an optional A-B RF switch (not supplied) to
switch between the cable and over-the-air antenna
programming, as indicated below.
Cable
Antenna
Note
• Be sure to set the Signal Type setting to Cable or
Antenna found under the Channel settings for your input
signal (page 20).
8
US
Rear of TV
CABLE/ANTENNA
A/B RF Switch
A
B
Rear of TV
CABLE/ANTENNA

HD Cable Box/HD Satellite Box

You can enjoy high-definition programming by
subscribing to a high-definition cable service or a
high-definition satellite service. For the best
possible picture, make sure you connect this
equipment to your TV via the HDMI or component
video (with audio) input located on the back of your
TV.
Shown with HDMI Connection
Rear of TV
Set Top Box