Toshiba e-studio206l Troubleshooting Manual page 35

1.TROUBLESHOOTING FOR THE HARDWARE
7
If the paper size is small, turn the knob shown in the following figures to send the
paper, and then remove the jammed paper.
When the Hole Punch Unit is installed, open the front cover of the finisher and turn the 2 knobs at the same
time.
When the Hole Punch Unit is not installed
8
Lower the shutter of the paper exit portion and
remove the paper.
9
Close the cover of the Bridge Unit.
10
Close the upper receiving tray of the finisher.
Place your hands on the near and far side of the lever and push to
close the tray until it clicks.
Be careful not to let your fingers be caught between the
finisher body and the upper tray of the finisher.
This could injure you.
The upper receiving tray of the finisher can also be closed by
pressing the right side of the lever.
1 TROUBLESHOOTING FOR THE HARDWARE
When the Hole Punch Unit is installed
2
Clearing a Paper Jam
1
33