NordicTrack ELITE 7500 User Manual page 10

7. Slide the Right Upright Sleeve (96) up against
the console assembly. Attach the Right Upright
Sleeve with two 3/4" Screws (4).
Attach the Left Upright Sleeve (not shown) to
the console assembly in the same way.
8. With the help of a second person, raise the
front of the treadmill and insert the crossbar on
the Base (83) into the cutout in the cardboard
stand as shown. Have the second person
hold the treadmill to prevent it from moving
forward or backward.
Firmly tighten the four Upright Bolts (72).
With the help of a second person, lower the
treadmill off the cardboard stand.
9. Note the location of the 75 ohm terminal and the
audio/video input jack on the treadmill. For the
television to operate, the Audio/Video Wire
Harness (115) must be connected to the
audio/video input jack on the treadmill or a CATV
cable or an antenna must be connected to the 75
ohm terminal (see page 11).
10. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex key
in a secure place; the hex key is used to adjust the walking belt (see page 30). To protect the floor or car-
pet from damage, place a mat under the treadmill.
7
8
83
72
9
10
Console
Assembly
4
96
4
72
Cardboard
Stand
Audio/
Video
Input
75 Ohm
Terminal
115