Two-bay LFF drive model (using the HP 250 W Integrated Power Supply or HP 300 W Integrated
o
Power Supply)
Four-bay SFF drive model (using the HP 750 W CS -48 V DC Power Supply)
o
Connect the optical drive SATA Y-cable:
7.
Connect the common end of the Y-cable to the optical drive.
a.
Connect the power end of the Y-cable to the power supply four-pin (1x4) cable.
b.
Route the data end of the Y-cable through the cable management partition, and then connect the
c.
cable to the system board SATA connector.
Secure the excess length of the Y-cable on the front left corner of the power supply:
d.
Hardware options installation 43