Blackridge 180 Hi-Flow User Manual page 12

Air FilTer
The supplied air filter must be used.
Failure to do so may result in irreparable damage
and will void the warranty, Pic. 8
To install:
1. Carefully screw supplied air filter into the
threaded hole on the top of the pump head.
This only needs to be done up by hand. Do not
use tools to tighten air filter.
NOTE: Do not OVER TIGHTEN as this may
damage the air filter or cylinder head which will
NOT be covered under warranty.
STArTiNg ANd SToppiNg
yoUr Air compreSSor
pic. 9
NOTE: Always ensure that you plug your air
compressor into a standard 240V AC power point.
Never use an extension cord as this can lead to a
voltage drop which may cause power loss and over
heating. Use a longer air hose if you need to get
closer to your work area.
Always start and stop the compressor using
the ON/OFF button on the Pressure Switch
(Pic. 1 Item 14 and 15 as well as Pic. 9).
Never use the power point switch to operate
the compressor as this will cause damage and
injury may occur. Damage caused by not using
this button will not be covered by warranty.
To turn your air compressor oN;
Lift up the red ON / OFF button on top of the
pressure switch
To turn your air compressor oFF;
Push down the red ON / OFF button on top of the
pressure switch
pic. 8
pic. 9
Lift button
up for on
12
Push button
down for off