ViewSonic N2635w-1M Service Manual page 9

1 Power Input Voltage Range
2 Input Frequency Range
3 Input Current
4 Power Supply Inrush
5 Power Consumption:
6 Interference with RF and Video
7 Electromagnetic Compatibility
Power Supply Transient Immunity
8
(Supply Transients and Outage)
9 Surge Immunity Test
Power Supply
10
Immunity
11 Power Supply Acoustics
12 Efficiency
13 Leakage Current
14 Power Saving(DPMS)
15 Recovery Time
16 Power Factor Correction
5. Firmware & OSD
The product firmware of VS11769-1M shall have a firmware version of V:P01 or later version.
Any changes/revisions afterward shall also be pre-approved by ViewSonic in written. For
VS11769-1M, its firmware shall have a built-in frequency table for NTSC/ATSC off-air TV/CATV,
Closed-Caption, and with MTS implementation.
All audio/video and other output adjustments shall be performed by using an On Screen Display
(OSD) via a Remote Control Unit (RCU) adjustment. The following tables list the OSD
functions supported by VS11769-1M.
OSD Table:
OSD
Picture Mode
Brightness
Contrast
Color
Tint
Sharpness
Color Temperature
Balance
Bass
Treble
ViewSonic Corporation
ELECTRICAL SPECIFICATION
100-240VAC +/- 10% Wide Range
47-63 Hz
3.0A @ 115VAC // 1.5A @ 230VAC
Max in < 150A (with fully loaded power supply) at
230Vac
Shall not result in permanent failure of power supply
(including blown fuse)
105 W (Normal), 135W (Max) // Stand by: < 3 W
There shall be no visible interference between power
supply, RF and video signals.
available RF channels and video modes.
This product shall adhere to the compatibility and
immunity specifications in FCC.
Able to withstand an ANSI / IEEE C62.41 – 1980 2000V
ring wave with no damage.
Able to withstand 1.25X nominal Line Voltage for one
cycle with no damage.
Missing Cycle Function properly without reset or visible screen artifact
when 1/3 cycle of AC Power is randomly missing.
The Power Supply shall not produce audible noise that
would be detectable by the user (Excluding Power Supply
Fan).
"Audible" shall be defined in accordance with ISO 7779
(DIN EN27779:1991).
Power Switch noise shall be Excluded.
>= 80% @ full load, nominal line
<0.5mA @ 240VAC
N/A
< 3 sec.
Compliant with EN61000-3-2
Picture effect selections on Cinema, Sport, Vivid, Hi-bright, and User
Adjust the Black levels
Adjust the White levels
Adjust the Color levels
Adjust the Tint levels
Adjust the Sharpness levels
Selections on Normal, Warm, user, Cold
Adjust the Speak output levels
Adjust the Low Frequency levels
Adjust the Hi Frequency levels
6
This applies to all
Confidential - Do Not Copy
N2635w-1M