Belt Clip And Headset - Gigaset C450 IP User Manual

First steps
If the handset battery is sufficiently
charged, the message key on the handset
will flash (around 20 minutes after you
have put the handset in the charging cra-
dle). Press the message key to start the
connection wizard.
If the connection wizard starts automati-
cally, a prompt will be displayed:
Press the display key to con-
§Yes§
firm the prompt.
Make the VoIP settings with the help of
the connection wizard.
Note:
The connection wizard will also start automat-
ically if you try to establish a connection via
the Internet, before you have made the neces-
sary settings.
You can also call up the connection wizard at
any time via the menu (page 38).
Making VoIP settings
Precondition: The base station is con-
nected to the Internet, i.e. the base station
is connected to the router and the router
has an Internet connection (page 9).
Downloading VoIP provider data
q
Select country and press
q
Select VoIP provider and press
.
§OK§
The necessary data for your VoIP provider
is downloaded and saved on the phone.
Note:
If the data for your VoIP provider is not availa-
ble for download, you can make the necessary
settings with the Web configurator (page 46).
Entering VoIP user data
Username:
If this is required by your pro-
vider, enter name and press
.
§OK§
Authentication Name:
Enter name and press
Authentication Password:
Enter password and press
10
If the settings are correct and complete, a
message will be displayed to this effect.
You can now use your phone to make calls
via the fixed network and the Internet!
Callers can reach you on your fixed
network number and your VoIP number!
Note:
To ensure that you can always be reached via
the Internet, the router should be permanently
connected to the Internet.

Belt clip and headset

By using a belt clip and headset (optional)
you can easily make your handset a con-
stant companion both inside the building
and in its immediate vicinity.
Attaching the belt clip
There are notches for attaching the belt
clip on the side of the handset at approxi-
mately the same height as the display.
¤
Press the belt clip onto the back of the
handset so that the protrusions on the
belt clip engage with the notches.
The tongue of the belt clip must face the
.
§OK§
battery compartment.
Connection socket for headset
You can use headsets with jack connec-
tors. The following models have been
tested and are therefore recommended:
HAMA Plantronics M40, MX100 and
MX150.
The transmission quality of other models
cannot be guaranteed.
.
§OK§
.
§OK§