Activating/Deactivating Display Of Voip Status Messages; Check The Base Station Mac Address; Operating The Base Station; On The Pabx - Gigaset C450 IP User Manual

Operating the base station on the PABX
Viewing/changing subnet mask
You can only change the subnet mask
(page 75) if you have deactivated dynamic
assignment.
¢ ¢
Settings
§Menu§
Configuration (enter system PIN)
¢
Configuration
The current subnet mask is displayed.
~
If necessary, enter subnet
mask and press
Note:
For notes on the subnet mask, please see
page 45 and the glossary on page 75.
Activating/deactivating display
of VoIP status messages
If the function is activated, a VoIP status
code for your service provider is displayed.
Activate the function e.g. if you have prob-
lems with VoIP connections. You will
receive a provider-specific status code,
which supports the service when the
problem is analysed.
¢ ¢
Settings
§Menu§
(enter system PIN)
Configuration
Configuration
Status on HS (‰ = on)
Select and press
Note:
For how to make the setting on the Web con-
figurator, see page 52.
40
¢
Base VoIP
¢
IP
Subnet Mask
.
§OK§
¢
Base VoIP
¢
IP
.
§OK§
Check the base station MAC
address
Depending on your network configura-
tion, it may be that you have to enter your
base station MAC address e.g. into your
router's access control list. You can check
your base station MAC address:
4 I O 2 Q
§Menu§
The base station MAC address is displayed.
a
Press and hold (idle status).

Operating the base station

on the PABX

The following settings are only necessary
when your PABX requires them; see the
PABX User Guide. The settings only con-
cern fixed network connections.
You cannot send or receive SMS messages
on PABXs that do not support Calling Line
Identification.

Changing the dialling mode

You can set the dialling mode.
¢ ¢
Settings
§Menu§
¢
Features Dialling Mode
Tone / Pulse
Select and press
a
Press and hold (idle status).
¢
Base Additional
(‰ = on).
§OK§