Step 3: Install The Swivel Or Vent Mount - XM XMp3 Installation Manual

Vehicle Installation

Step 3: Install the swivel or vent mount

You can use either the included swivel mount or vent mount for your XMp3 radio depending
on your vehicle interior.
Installing the swivel mount
CAUTION! The adhesive used with the swivel mount may make it diffi cult to remove. Do not
install this mount on leather surfaces and make sure the air temperature is at least 60°F (15°C)
during installation.
1 1
Locate a fl at surface for the mount. Make sure there is ample room for the XM
cradle and radio when installed.
2 2 Clean the surface with the preparation kit and let it dry thoroughly.
3 Peel off the adhesive liner. Position, press, and hold the swivel mount in place
for 30 seconds.
IMPORTANT! Let the adhesive cure for 24 hours before attaching the XM cradle and
radio to the mount.
4 Turn the swivel to accommodate the XM cradle and radio. Adjust the tension
via the center screw.
10
To remove, carefully lift the adhesive pad with your fi ngers or a spoon. Warming the pad with a
hair dryer for several minutes will help soften the adhesive.
You can reinstall the swivel mount using the extra adhesive pad.
Installing the vent mount
1 1
Locate a vent with horizontal slats
sturdy enough to hold your XM cradle and radio.
2 2 Adjust the clamps to fi t your vent.
3 3 Snap the mount onto the vent.
To remove, push the mount into the vent, then lift up.
You can adjust this screw
to adjust the tension of the
mount with a screwdriver.
11