Engine Stop Switch
The stop switch is a red colored rocker switch located
on the left‐hand handlebar.
To start and run the engine, this switch must be
placed in the on,
position.
The vehicle is also equipped with a safety brake
switch which will prevent the engine from starting
until the parking brake is engaged.
To stop your engine, place the switch to the stop,
In the stop,
Position the ignition system is
grounded preventing the spark plug from firing.
This switch can also be used as a safety or emergency
stop switch.
Turn Signal Switch
The turning signal switch is a three position switch
located on the left‐hand handlebar. Sliding the switch
in the direction of the intended turn will illuminate
the front and rear turn signal lamps in a blinking
mode. Pressing the white button, on the center of
the switch, will return the switch to the neutral
position and cancel the illumination of the turning
lamps.
Copyright ©2008-2009 ETON America, all rights reserved.
Control Feature Operations
Position
Horn Button
The horn button is a yellow push switch, located
below the turning signal lamp switch on the left‐hand
handlebar. Pressing in on the button will sound the
audible horn signal. Releasing the button will silence
the horn.
Head Light Control Switch
For safety, the head light system of this unit was
designed to be illuminated at all times while the unit
is running. The intensity of the light is changed by
using the head light control switch located on the
right‐hand handlebar. It is a three position slide
switch. Far right position sets beam intensity to 20%
(Day Time Running), middle position sets beam
intensity to 80% (Low Beam), and far left position
sets beam intensity to 100% (High Beam).
The vehicle is equipped with a PTC controller that will
dim the lights to the 20% position automatically if the
engine RPM falls below the pre‐set threshold for
more than a minute. Increasing the engine RPM will
return the light to the normal level for the control
switch selection.