Manual Choke Lever
This scooter is equipped with a manually operated
carburetion choke system. The engine choke lever is
used to enrich the fuel mixture when starting the
engine from a cold start.
When first starting the engine,(cold start) ,place the
lever in the full left position, (Choke closed or on) After
allowing the engine to warm up for 15‐20 seconds,
slowly move the lever back to the right until the engine
idles down runs smooth.
The lever to the full right is the normal operation
position. (Choke open or off).
Throttle Control
The throttle control is the right‐hand handle grip.
Throttle is controlled by twisting the grip. The throttle
control is spring loaded and set at the factory to return
to the idle position when pressure is released.
To increase the throttle, twist the handle grip in a
counter clockwise rotation. To decrease throttle, twist
the hand grip in a clockwise rotation or release your
pressure and allow the throttle to return on its own.
Copyright ©2008-2009 ETON America, all rights reserved.
The throttle cable should be adjusted so there is
5‐10mm, (¼"), free travel of the throttle hand grip
before the throttle starts to open.
Keep the throttle cable lubricated and operating
smoothly. If the cable sticks or is hard to operate,
lubricate the cable by disconnecting the cable from the
throttle hand grip and lubricating with a commercial
cable lubricant available at your dealer.
Replace the cable if it shows signs of fraying or
corrosion or is kinked or bent.
To adjust the throttle cable's free play, slide the
protective cover down the cable to expose the cable
adjusting system. Loosen the locking nut and adjust
the cable length by turning the adjusting collar. Check
the free travel in the throttle hand grip until you have
5‐10mm, (
1
against the adjusting collar and slide the protective
cover over the adjusting system.
Replace the cable if there is no adjustment remaining
or the proper free travel cannot be obtained with the
adjustment system.
Brake Systems
Front and Rear Brakes
This vehicle is equipped with front hydraulic disc brake
and a rear hydraulic disc brake.
The front brake is controlled by the long brake lever on
the right‐handlebar. The rear brake is controlled by the
long lever on the left‐Handlebar.
") free travel. Tighten the locking nut
/
4
8