Purging The Brake Lines; Fuel System; Fuel Tank; Fuel Cap - E-TON Beamer R4 Owner's Manual

Purging the Brake Lines
For the hydraulic brake system to operate safely, the
brake system must be purged of air in the lines and
reservoir.
To bleed the air will require two people to perform the
following procedure.
Place a drain pan under the brake caliper to catch the
fluid.
1. Open the bleeder valve 1/2 turn counter
2. Squeeze the brake lever to expel air from the
system.
3. While holding the brake lever, close the bleeder
valve.
4. Repeat steps 2 through 4 until the brake fluid
coming from the bleeder valve is a solid stream
without any air, then close the valve and
replace rubber protection cap.
5. Test the brake system by squeezing the lever.
6. The lever should feel firm and stop without
fading.
Fuel System
Fuel Tank
The fuel tank fill cap is located at the rear of the
vehicle just behind the seat. Your vehicle is equipped
Copyright ©2008-2009 ETON America, all rights reserved.
with a locking fuel tank cap that is opened with the
same key that is used in the ignition switch.
To unlock your cap simply insert the ignition key into
the lock and turn clockwise until the cap releases. Lift
the cap from the tank and refuel your vehicle with
unleaded automotive grade gasoline of 89 octane or
higher.
Fuel Cap
To replace the cap, align the Locator lug on the cap
with the notch in the tank neck and press the cap
down until you hear the locking lugs click.
Every time you refuel your unit, check the rubber seal
inside the cap for cuts, tears and dirt. Clean or replace
the seal if it becomes worn or torn.
The seal must be in good condition to ensure a proper
seal of the cap to the tank to prevent fuel spills. DO
NOT allow dirt or other debris to enter the tank when
refueling.
11