Table of Contents
Advertisement
1MRS 750107-MUM
5.3.
5.4.
ABB Automation
Serial LonTalk™ Adapter
Technical Reference Manual
Fibre-optic interface
For more information regarding the fibre-optic connection of option cards, refer to
the RER 111 manual 1MRS750104-MUM, chapter 6.2.
Service switch
The service switch is used to produce a service-pin message. This message can then
be used by the network management device (e.g. higher level processors, PC, etc.)
to install and configure the SLTA option card. When the switch is pressed and
released, the SLTA generates a service pin message. The service pin message is sent
to the L
W
network, NOT to the RS232 interface.
ON
ORKS
SLTA Option Card
11
Advertisement
Table of Contents
