Power Requirements; System Specifications - Pro-Weld CD-212 Operation & Maintenance Manual

PRO
This technique, when equipment is set up properly,
is simple and easily mastered. The same power sup-
ply is capable of welding many different sizes and
materials of fasteners. If you require assistance in
selecting the proper accessories, contact our cus-
tomer service department or your field representa-
tive.

7.0 POWER REQUIREMENTS

110 VOLT OPERATION
110 volt AC 60 H:
Circuit protection:
Integral 9 foot power cord
IF EXTENSION REQUIRED
Cable Length
12'
25'
30'
50

8.0 SYSTEM SPECIFICATIONS

Weight:
26 Lbs.
Size:
9" W x 11 3/4" D x 8 1/2" H
22.9 cm W x 29.8 cm D x 21.6 cm H
Chassis:
14 Ga. Aluminum (Painted International
Orange)
Panel Controls:
Power
Voltage Controls
Weldable Materials:
Steel, Stainless steel, Aluminum, Copper,
Brass, Zinc coated, Galvanized
Weldable Stud Diameter:
14 Ga. Through 1/4" Flanged
(Max W.B. Dia. For AL=5/16" (1/4" thread)
Weld Rate:
12 per minute
Weld Voltage:
45-200 VDC
WEL D
20 amps;
15 amp circuit breaker
(P/N: 104-0020)
110 Volt
#16/3
#16/3
#14/3
#12/3
Weld Mode:
Contact
Polarity:
Straight or Reverse
Power Required:
110 Volt AC 60 Hz 20 Amp
Circuit Protection:
15 Amp circuit breaker
3AG 1 Amp 250 volt fuses
(2 on PC Board)
STANDARD GUN & CABLE SPECIFICATIONS
WELD GUN-LIGHT DUTY PRECISION
CD CONTACT
Part Number:
300-0100 B Collet Gun
300-0101 Taper Tip Gun
Weight:
2 lbs. (not including cable)
( lbs. (including 25 ft. #4 weld cable & 16-4
SOW control cable)
Size:
6 1/2" x 5 3/4" x 2"
Weldable Stud Diameter:
14 Ga. Through 1/4" Flanged
Material:
High strength, impact resistant, glass fiber re-
inforced polycarbonate
Integral Gun Cable Length:
25 feet – #4 AWG
Connectors:
Male Camlok / 2 Pin Hubbell Male
Cables
Ground Cable:
(1) #4 x 15' (P/N: 125-0100)
CD -2 1 2
Page 3