Bonnet - Ford Ka 2008 Owner's Handbook Manual

047-064 Ford KA GB 15-07-2008
Rear seat repositioning
Raise the seat backrests and push them
back until hearing the locking click of
both retainers.
Position the seat belt buckles up.
IMPORTANT When returning the
backrest to the position of use, make
sure it is correctly fastened and you
hear the lock click.
Make sure the backrest is properly
secured at both sides to prevent it
moving forward in the event of sharp
braking causing injuries to passengers.
REMOVING THE REAR
PARCEL SHELF
To remove the rear shelf, release it from
its two side pins and pull it out.
8:50 Pagina 49

BONNET

Opening fig. 46-47-48
Proceed as follows:
❒ pull lever A in the direction of the
arrow;
❒ move to the right the lever B as
shown in figure;
❒ lift the bonnet and at the same time
release the support rod C from its
locking device D, then insert the end
of the rod in the seat E of the engine
hood (bigger hole) and push to safety
position (smaller hole), as shown in
figure.
WARNING
If the supporting rod is not
positioned correctly the
bonnet may fall violently. Perform
these operations when the car is
stationary only.
A
fig. 46
B
fig. 47
KA00038m
KA00039m
49