Ford Ka 2008 Owner's Handbook Manual page 20

001-025 Ford KA GB 15-07-2008
Speed beep (Speed limit)
With this function it is possible to set
the car speed limit (km/h or mph);
when this limit is exceeded the driver is
immediately alerted (see section
"Warning lights and messages").
To set the speed limit, proceed as
follows:
– briefly press button MENU
display will show the message (Speed
Buzz);
– press button + or – to select speed
limit activation (On) or deactivation
(Off);
– if the function has been activated
(On), press buttons + or – to select the
required speed limit and then press
MENU to confirm.
ESC
Note The speed may be set in the range
from 30 to 200 km/h, or from 20 to 125
mph according to the previously chosen
unit (see "Setting the distance unit")
described below. The setting will
increase/decrease by five units each time
button + / – is pressed. Hold button + / –
pressed to increase/decrease the setting
rapidly. Complete the setting by briefly
pressing the button when the required
setting is approached.
8:51 Pagina 19
– briefly press button MENU
go back to the menu screen or press
the button for a long time to go back to
the standard screen without storing
settings.
To cancel the setting, proceed as
follows:
– briefly press button MENU
(On) will flash on the display;
, the
ESC
– press button –: (Off) will flash on the
display;
– briefly press button MENU
go back to the menu screen or press
the button for long to go back to the
standard screen without storing
settings.
Trip B data (tripB on)
Through this option it is possible to
activate (On) or deactivate (Off) the
Trip B (partial trip) display.
For further information see "Trip
computer".
For activation / deactivation, proceed as
follows:
– briefly press button MENU
(On) or (Off) will flash on the display
(according to previous setting);
– press button + or – for setting;
– briefly press button MENU
go back to the menu screen or press
the button for long to go back to the
standard screen without storing
settings.
to Setting the time (Clock)
ESC
This function enables to set the clock
through two sub-menus: "Time" and
"Format".
Proceed as follows:
– briefly press button MENU
display will show the two sub-menus
: "Time" and "Mode";
ESC
– press button + or – to surf the two
sub-menus;
– select the required option and then
press button MENU
to
ESC
– when accessing the "Hour" submenu:
briefly press button MENU
"hours" will flash on the display;
– press button + or – for setting;
– briefly press button MENU
"minutes" will flash on the display;
– press + or – to make your choice;
:
ESC
to
ESC
, the
ESC
;
ESC
,
ESC
,
ESC
19