Sharp MZ-700 Series Owner's Manual page 149

5.1 Monitor Commands
The monitor program starts immediately after the power is turned on and awaits input of a monitor
command. The monitor commands are listed below. In this chapter, |CR| indicates that the carriage return
key is to be pressed.
L command Loads cassette tape files into memory.
P command Outputs the specified character string to the printer. (Print)
M command Changes the contents of memory. (Memory correction)
J command
Transfers control to the specified address. (Jump)
S command Saves the contents of the specified memory block to cassette tape. (Save)
V command Compares the contents of cassette tape with the contents of memory.
# command Transfers control to the RAM area.
B command Makes the bell sound every time a key is pressed. Executing this command
again stops the bell.
• Configuration of the monitor work area
The configuration of the monitor work area from $ 1000 to $ 11FF is shown below.
$ 0 0 0 0
$ 1 000
$ 1 O F O
$ 1 1 7 0
$ 1 1 A 3
$1 2 0 0
Monitor
Stack area
Cassette tape
header area
Variable area
Key input data area
Free area
146-
Note: The R O M monitor described in this chapter is not the same as the monitor function of the BASIC
interpreter.