Sharp MZ-700 Series Owner's Manual page 102

2.11.4 Memory set command
(M command)
Format ~| * M [starting address]
This command is used to change the contents of memory. If the starting address is omitted, the address
currently indicated by the program counter is assumed. Press the| SHIFT | and I BREAK] keys together
to terminate this command.
When this command is entered, the starting address of the memory block and its contents are dispalyed
in the editing format described previously and the cursor is moved to the data to be changed. Enter the
new data and press the |CR| key; the following address and its contents are then displayed.
2.11.5 Fin command
(F command)
Format ~ | * F [starting adress] ^ [end adress] [data] [data]
This command searches for the specified data string in the memory area from the starting address to
the end address. When found, the address of the string and its contents are dumped to the screen. This
command js terminated by simultaneously pressing the I SHIFT 1 and | BREAK] keys.
2.11.6 Subroutine call
(G command)
Format | * G [call address]
This command calls the subroutine starting at the specified address. The stack pointer is located at
FFEEH.
2.11.7 Transfer command
(T command)
Format * T [starting address] [end address] [destination adress]
This address transfers the contents of memory between the starting address and the end address to the
memory area starting at the destination address.
2.11.8 Save command (s
command)
Format * S[starting address]^ [end a d r e s s ] [ e x e c u t i o n adress] : [file name]
This command saves the contents of the memory between the. starting address and the end address to
cassette tape under the specified file name.
00-