Sharp MZ-700 Series Owner's Manual page 111

Ordinary cassette tape recorder
Using commercially available audio cables with 3.5 mm mini-plugs, connect the WRITE jack of the
computer to the MIC jack of the cassette tape recorder and connect the computer's READ jack to the
EXT SP or EAR jack of the cassette tape recorder.
Take note of the following when using an ordinary cassette tape recorder.
(1) The message " i . R E C O R D . P L A Y " does not appear when a SAVE command is entered.
Be sure to press the RECORD key On the recorder before entering this command. Press the STOP
key to stop the recorder after the message " READY " is displayed. Without depressing the STOP key,
the recorder is not stopped.
MIC
E A R
R E A D
W R I T E
(2) The message ± P L A Y
1
does n o t appear when a LOAD command is entered. Be sure to start
playing the tape after entering the command. The message "READY" is displayed when loading is
completed.
(3) The level and tone controls of the cassette tape reocrder must be adjusted to appropriate levels. Some
cassette recorders (e.g. those with the automatic level control) may not be usable. In such cases,
please purchase the MZ-1T01.
(4) The polarity of the head can make it impossible to load programs provided with the computer. Try
switching the head polarity if programs cannot be loaded.
(5) For any transfer or collation, use the tape recorder that was used for recording. If the tape recorder
for transfer or collation is different from that used for recording, no transfer nor collation may be
possible.
(6) Data written using an ordinary cassette recorder may not be readable with the data recorder. There-
fore, use of the MZ-1T01 is recommended.
109-