Sharp MZ-700 Series Owner's Manual page 113

• Loading roll paper
1. Remove the printer cover.
2. Cut the end of roll paper straight across and insert the end into the paper inlet. (Be careful to avoid
folding or wrinkling the end of the paper when doing this.)
3. Turn on MZ-731's power switch and press the El (paper feed) key to feed paper until the top of
paper is 3 to 5 cm above the outlet.
4. Insert the paper shaft into the roll and mount it to the paper holders.
5. Set the printer cover so that the end of paper comes out through the paper cutter.
• To remove the roll from the printer for replacement, cut straight across the paper at the paper
inlet and press the paper feed key.
• Roll paper for the MZ-700 series computers is available at any Sharp dealer. Do n o t use paper other
than that specified.
The length of the paper is 23 to 25 meters, and the maximum roll diameter which can be loaded
is 50 mm. Paper will not feed properly if a roll with a greater diameter is used, resulting in poor
print quality.
Procedures for loading roll paper
(A) Insert paper into the paper inlet.
(C) Replace the printer cover.
(B) Press the paper feed key to feed paper.
111-