Data Recorder - Sharp MZ-700 Series Owner's Manual

3.3 Data Recorder
• Data recorder built into the MZ-731 and MZ-721
The built-in data recorder can be operated in the same manner as an ordinary cassette tape recorder.
Press this key to record programs and data.
Press this key to load programs and data.
Press this key to rewind the tape.
Press this key to fast-forward the tape.
Press this key to stop the tape, to release other keys when the tape stops after
loading or recording programs or data, or to eject the tape.
RECORD
PLAY
REWIND ~
FFWD
STOP/EJECT
• MZ-1T01
The MZ-1T01 data recorder unit can be installed in the MZ-711 (MZ-710). Installation procedures are
as follows.
1. Turn off the computer's power switch and unplug the power cable from the AC outlet.
2. Remove the two screws located on the left side of the rear panel to remove the data recorder com-
partment cover.
Polarity switch
Joint connector
3. Remove the joint connector cover.
4. Plug the connector of the MZ-1T01 onto the 9-pin connector located at the left rear of the recorder
compartment of the MZ-711.
5. Position the data recorder in the recorder compartment and fasten it in place with the two screws.
When doing this, be careful to avoid catching the connector cable between the data recorder and
the computer, (otherwise, the screws cannot be tightened).
108-