Installation and commissioning
8
Fitting the synchronizer
.01.06
8
Fitting the reel stand
.01.07
8 - 4
3
1
Fig. 8 - 06
Fig. 8 - 07
Attach position stop 1 using screws 2.
Push synchronizer 3 onto the shaft so that
the position stop 1 is in the groove of the
synchronizer (see arrow).
Slightly tighten screws 4.
Insert the synchronizer plug in the
connection socket of the control box.
4
Adjust the synchronizer 3 (see Chapter
11.04.01 Adjusting the Synchronizer).
2
Fit the reel stand as shown in Fig. 8-07.
Afterwards insert the stand in the hole in
the table top and secure it with the nuts
provided.