Omron SYSDRIVE 3G3JVS ERIES User Manual page 147

List of Parameters
Parame- Name
ter No.
n01 Parameter
write-prohibit
selection/pa-
rameter initial-
ization
n02 Operation
mode selection
n03 Frequency ref-
erence selec-
tion
n04 Interruption
mode selection
n05 Reverse rota-
tion-prohibit
selection
9-2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Description
Used to prohibit parameters to be written,
sets parameters, or change the monitor
range of parameters.
Used to initialize parameters to default val-
ues.
0: Sets or monitors parameter n01. Param-
eters n02 through n79 can be monitored
only.
1: Sets or monitors parameters n01
through n79.
6: Clears the error log.
8: Initializes parameters to default values
in 2-wire sequence. (Japan)
9: Initializes parameters to default values
in 3-wire sequence. (Japan)
10: For North America, initializes
parameter in 2-wire sequence.
11: For North America, initializes
parameter in 3-wire sequence.
Used to select the input method for the
RUN and STOP commands in remote
mode.
0: The STOP/RESET Key on the digital
Operator is enabled.
1: Multi-function inputs through the control
circuit terminals in 2- or 3-wire se-
quence.
Note The RUN command only through key
sequences on the Digital Operator is
acceptable in local mode.
Used to set the input method for the fre-
quency reference in remote mode.
0: Digital Operator
1: Frequency reference 1 (n21)
2: Frequency reference control circuit ter-
minal (0 to 10 V)
3: Frequency reference control circuit ter-
minal (4 to 20 mA)
4: Frequency reference control circuit ter-
minal (0 to 20 mA)
Used to set the stopping method for use
when the STOP command is input.
0: Decelerates to stop in preset time.
1: Coasts to stop (with output shut off by
the STOP command)
Used to select the operation with the re-
verse command input.
0: Reverse enabled.
1: Reverse disabled.
Set- Unit Default Changes
setting
ting of set-
range ting
0, 1, 6, 1 1 No
8, 9
0, 1 1 1 No
0 to 4 1 2 No
0, 1 1 0 No
0, 1 1 0 No
Chapter 9
Refer-
during ence
opera- page
tion
5-2
5-7
5-8
5-17
5-16