Table of Contents
Advertisement
09 Maintenance and specifications
WARNING
Connect and disconnect the positive and
negative cables in the correct sequence.
Removal
Switch off the ignition, remove the remote key
from the ignition slot and wait at least
5 minutes before disconnecting the battery so
that all information in the vehicle's electrical
system can be stored in the control modules.
Open the clips on the front cover and
remove the cover.
Release the rubber molding so that the
rear cover is free.
Remove the rear cover by pulling it away.
Detach the black negative cable.
Detach the red positive cable
Detach the ventilation hose from the
battery
Loosen the screw holding the battery
clamp.
Move the battery to the side and lift it up.
WARNING
PROPOSITION 65 WARNING!
Battery posts, terminals, and related
accessories contain lead and lead com-
pounds, chemicals known to the state of
California to cause cancer and reproduc-
tive harm. Wash hands after handling.
Installation
1. Lower the battery into the battery box.
2. Move the battery inward and to the side
until it reaches the rear edge of the box.
3. Tighten the clamp that secures the bat-
tery.
4. Connect the ventilation hose.
> Be sure that it is correctly connected
to the battery and the vent in the vehi-
cle's body.
5. Connect the red positive cable.
Battery
09
337
Advertisement
Table of Contents
